Language

Maintenance method of plate laser cutting machine?

2023-05-11

FONT

To know that now any machine in the use of the process must pay attention to maintenance. The stability and normal operation of the machine is inseparable from the daily maintenance. Because only the correct maintenance method can not only improveplate laser cutting machineThe work efficiency can also extend the service life.

What the plate laser cutting machine should do during maintenance is to change the water and clean the water tank. Before the machine works, please make sure that the laser tube is filled with circulating water. The water quality and the temperature of the circulating water directly affect the service life of the laser tube. It is recommended to use pure water, control the water temperature below 35 ℃, replace the circulating water above 35 ℃, or add ice to reduce the water temperature and add water. The next step is to turn off the power, unplug the water inlet hose, let the laser tube automatically enter the water tank, open the water tank, draw out the water, and clear the dirt on the water pump. Clean the water tank, replace the circulating water, put the water pump back into the water tank, insert the connecting pipe into the water inlet of the water pump, and arrange the joint. Use pump power alone and run for 2-3 minutes. And then it wasplate laser cutting machineThe cleanliness of the fan, especially after long-term use, will cause a large amount of solid dust to accumulate inside the fan, and will also cause the fan to make a lot of noise, which is not conducive to exhaust deodorization. When the fan with insufficient suction does not emit smoke smoothly, the power supply should be turned off first, the fan should be discharged into the air duct and air duct, the dust inside should be cleaned, then the fan should be installed and the air duct inside should be removed. Until the blades are clean, then install the fan. Then the plate laser cutting machine can support the carbon dioxide laser machine to work normally.

Plate laser cutting machine in the maintenance of the need to do is to clean the lens. When introducing the machine before, he said that the engraving machine has 3 mirrors and 1 focusing mirror, and the focused laser is reflected by the lens and emitted by the laser. The lens can easily come into contact with dust or other contaminants, resulting in loss or damage to the laser lens. Of course, you don't need to take it out at this time. When cleaning the lens, you need to dip the cleaning lens paper with cleaning liquid and carefully wipe the rotation direction along the side of the center of the lens. The lens and its focus lens are wiped from the frame in the same way and returned after the wiping is complete. What needs to be noted here is that the lens of the plate laser cutting machine should be gently wiped to avoid damage to the surface coating; it should be removed and gently wiped to avoid falling; in short, the smoke and dust generated by engraving and cutting after a period of use will corrode the guide rail, so Maintain the guide rail regularly, turn off the power of the plate laser cutting machine, wipe the guide rail with a clean soft cloth, and then drop lubricating oil on the guide rail.

The above article content is for each friend to tellplate laser cutting machineThe maintenance method, but also in the content to share a better plate laser cutting machine manufacturers, if you have this demand can go to check, hope to bring you help.