How to solve the problem of abnormal reset of metal laser cutting machine?
Laser cutting machine is a commonly used modern processing equipment. There will always be some headaches during use, especially its abnormal reset. This is also a problem that everyone is more concerned about. The following is a pairmetal laser cutting machineBrief introduction of abnormal reset.
How to solvemetal laser cutting machineAbnormal reset problem?
1. Check whether there is dust, poor contact or damage on the sensor (clean or replace the dust on the sensor);
2. Checkmetal laser cutting machineFlexible conductive tape data cable for poor contact or damage (trim the data cable and re-plug or replace the data cable);
3. Check whether the grounding wire is reliable or whether the high-voltage line is damaged (re-grounding or replacing the high-voltage line);
4. Poor contact of the motor line.
metal laser cutting machineMissing engraving occurs, initialization is incorrect, and data has been sent (corrected); operation sequence is reversed (re-input); electrostatic interference (check whether the ground wire is disconnected and restarted); computer system error (reinstall the operating system and software); check whether the left and right belts are consistent or whether the rear belt is too loose (belt tension); check whether the belt or synchronous wheel slips or jumps (belt); check that the beams are parallel (readjust the left and right belts).
Tag:
Recommended

